How To Install Kitchen Cabinets Handles

Drill the screw mounting hole with a drill bit with a drill of the appropriate size.

How to install kitchen cabinets handles. Adjust the horizontal bar to desired position. Youll specifically want to place them anywhere between 1 and 4 from the top or bottom edge of the door. 2 Measure and Mark Locations for New Handles.

When it comes to installing cabinet door handles either knobs or pulls they are always placed on the opposite side from the door hinges. Drill the hole with a modest drill bit and finally screw in the hardware. Install Hardware Higher on the Lowest Drawer Most drawer pulls are centered on the drawer fronts but if the cabinet youre working on has two or three drawers the same size and one larger one at the bottom install the bottom knob or pull higher than the center of that drawer front.

If you are replacing cabinet handles youll need to first remove the old handles. To drill holes in cabinet pulls decide where you want to place each accessory first. Choose a drill bit slightly bigger than the screw and drill your holes.

Most drawer pulls are centered on the drawer fronts but if the cabinet youre working on has two or three drawers the same size and one larger one at the bottom install the bottom knob or pull higher than the center of that drawer front. Install it so all the knobs on the cabinet are spaced evenly. Keep drill as level as possible Hold the pulls to the front of the door and screw the bolt in from the back of the cabinet or drawer.

If you have an extra. Measure the installation position on the cabinet door. Install it so all the knobs on the cabinet are spaced evenly.

Assuming that you want them to be 1 from the corner you can place a mark 1 down and 1 over from the corner of your page. Once theyre both in tighten away. Your cabinet pulls dont have to be the same size however it will make the repetition of hardware install more straightforward.