Installing Molding On Kitchen Cabinets

Miter the edge that meets the first strip of crown molding and hold the ends together.

Installing molding on kitchen cabinets. The gusset is just a piece of wood that is attached to the top of your cabinet using glue and brads and the crown molding is attached to the gusset to provide additional strength to the molding. Click to see full answer. It may not be a concern if you have done this before and you have a miter saw at home.

Cut strips of straight 34-in x 1-12-in wood to fit the front and sides of each cabinet. Installing crown molding on kitchen cabinets takes a whole lot of accuracy and precision in cutting especially the corners. Measure from the top of the installed cabinet to the bottom edge.

Hold up the crown molding on the sides of the cabinet. The gusset creates an inside corner between the molding and cabinet top. Check out our video REVIEW and DEMO of adding CROWN MOLDING to your KITCHEN CABINETS.

Apply the nail hole filler to fill the nail holes and any gaps at the corners and finally smooth the surface with the 320-grit sanding sponge. Position the piece of scribe molding along the seam where the back of the cabinet meets the wall. For upper cabinets set the cabinet on a cabinet jack.

Use one long strip for a row of cabinets the same depth Then apply wood glue to each strip nail it in place and let dry. Miter that end of this strip and then attach it to the backing wood with the nail gun. You can refer to this video for reference.

With these three steps you can install crown molding on your cabinets. If you dont worry not. Httpsbitly2CHOLXK Sweet new drone httpsamznto2SP3VQg The fancy glue I used.